Standard – ASTM C522 – Standard Test Method for Airflow Resistance of Acoustical Materials


Air Permeability Testing Equipment ->

ASTM C522 – Standard Test Method for Airflow Resistance of Acoustical Materials

Significance and Use

5.1 The specific airflow resistance of an acoustical material is one of the properties that determine its sound-absorptive and sound-transmitting properties. Measurement of specific airflow resistance is useful during product development, for quality control during manufacture, and for specification purposes.

5.2 Valid measurements are made only in the region of laminar airflow where, aside from random measurement errors, the airflow resistance (R = P/U) is constant. When the airflow is turbulent, the apparent airflow resistance increases with an increase of volume velocity and the term “airflow resistance” does not apply.

5.3 The specific airflow resistance measured by this test method may differ from the specific resistance measured by the impedance tube method in Test Method E384 for two reasons. In the presence of sound, the particle velocity inside a porous material is alternating while in this test method, the velocity is constant and in one direction only. Also, the particle velocity inside a porous material is not the same as the linear velocity measured outside the specimen.

1. Scope

1.1 This test method covers the measurement of airflow resistance and the related measurements of specific airflow resistance and airflow resistivity of porous materials that can be used for the absorption and attenuation of sound. Materials cover a range from thick boards or blankets to thin mats, fabrics, papers, and screens. When the material is anisotropic, provision is made for measurements along different axes of the specimen.

1.2 This test method is designed for the measurement of values of specific airflow resistance ranging from 100 to 10 000 mks rayls (Pa·s/m) with linear airflow velocities ranging from 0.5 to 50 mm/s and pressure differences across the specimen ranging from 0.1 to 250 Pa. The upper limit of this range of linear airflow velocities is a point at which the airflow through most porous materials is in partial or complete transition from laminar to turbulent flow.

1.3 A procedure for accrediting a laboratory for the purposes of this test method is given in Annex A1.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4.1 Table 1 is provided for user to convert into cgs units.

cgs acoustic ohm

mks acoustic ohm (Pa·s/m3)


cgs rayl

mks rayl (Pa·s/m)


cgs rayl/cm

mks rayl/m (Pa·s/m2)


cgs rayl/in.

mks rayl/m (Pa·s/m2)


mks rayl/in.

mks rayl/m (Pa·s/m2)


2. Referenced Documents

ASTM Standards

ASTM C634 Terminology Relating to Building and Environmental Acoustics

ASTM E384 Test Method for Microindentation Hardness of Materials

ASTM E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method


Absorption – Acoustical Absorption – Acoustical Insulation – Airflow Resistance – Airflow Velocity – Attenuation – Distance, Speed And Acceleration – Physical Properties – Sound – Sound, Noise

Air Permeability Testing Equipment ->

Air Permeability Testing Standards ->


There are no reviews yet.

Be the first to review “Standard – ASTM C522 – Standard Test Method for Airflow Resistance of Acoustical Materials”

Your email address will not be published. Required fields are marked *